ORLIC

[VinceC]

That is where I get mine from, but make sure you have swivel in the line

[Barry_Cole]

I may have said this before...

These are good. Non stretch. Non conductive. Build the tubes in as you go.

Second one down.

There is a longer set if you need it.

Simples.

http://www.sloughrc.com/default.asp?WPG ... b:Sullivan

BC

[Geoff Pearce]

Thanks Vince and Barry,
Just playing

Not bad for £12.60 , three d print head and hands To follow

[Geoff Pearce]

Doing a bit more on the back end,elevator and rudder, when done will take pics.
Also had head 3D scanned for pilot figure! Me?

GP

[roo Hawkins]

Hi Geoff is it handsome like you

[Geoff Pearce]

Roo,
You been drinking that Coalville punch again?
I have been putting together the tail plane and rudder assemble picks soon if it works out
Geoff

[Geoff Pearce]

1/2 scale head and hands just arrived in the post pics soon

GP

[Pat Marsden]

I guess Geoffs pilot had been standing a little to close to the windsock

[Geoff Pearce]

I guess Geoffs pilot had been standing a little to close to the windsock

Or to close to low flying tug pilots?

[Geoff Pearce]

Ok. This could be a bit scary to the faint hearted.

My 46% pilot total cost £66

Needs painting

Geoff