Futaba 12FG programming help
Posted: 04 Jul 2016, 13:19
No doubt about it the futaba 12 fg is a good set however at times frustrating ----- Like now
I just completed a Hanger 9 Valiant glider tug and have it set up as 2Ail+2Flp wing. So I want to put the flaps on a 3 position switch and have the ability to add elevator comp; at 20 deg flap and 40 deg flap.
I studied the manual for hours now and have tried looking on different forums where there all manor of methods for doing this.
I have assumed that the 'flap' function should be used and then elev-flp compensation used ??
The question I have is in the function menu do I leave the control section blank for the flaps i.e -- for both flaps and then allocate the switch within the flap function, am I correct ??
I have been advised to use a virtual channel VC1 and allocate this to the flap function.
Any help would be appreciated as I am confused, I have tried most things and I cannot get what I think to be a straight forward function to work correctly
I just completed a Hanger 9 Valiant glider tug and have it set up as 2Ail+2Flp wing. So I want to put the flaps on a 3 position switch and have the ability to add elevator comp; at 20 deg flap and 40 deg flap.
I studied the manual for hours now and have tried looking on different forums where there all manor of methods for doing this.
I have assumed that the 'flap' function should be used and then elev-flp compensation used ??
The question I have is in the function menu do I leave the control section blank for the flaps i.e -- for both flaps and then allocate the switch within the flap function, am I correct ??
I have been advised to use a virtual channel VC1 and allocate this to the flap function.
Any help would be appreciated as I am confused, I have tried most things and I cannot get what I think to be a straight forward function to work correctly