Page 1 of 4

SG38 1/4 Scale (Krick)

Posted: 28 Oct 2019, 21:51
by Wayne
OK so I finally found my way back to the building board to build my long awaited 1/4 scale SG38 which I purchased several years ago.

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 00:04
by Wayne
All of the instructions for the kit are in German, fortunately when I purchased the kit a few years agao I had the foresight to source a translated version.
So if anyone else is thinking of building one of these you'll more than likely need these translated instructions which can be found here:

Hope this helps.

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:01
by Wayne
OK so lets start with the fuselage:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:04
by Wayne
Some of the hardware:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:07
by Wayne
Fuselage and "A" frame assembly:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:10
by Wayne
Wing centre section:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:12
by Wayne
This is Tony:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 09:39
by Wayne
LOL :lol: Yes I don't hang about, should be done by lunch time 8-)

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 10:15
by Wayne
Skid Lamination & Shock Absorbers:

make up lamination spacers and angle pads for Ply, trace out from plan, make template, soak in hot water, glue bend slowly while attaching clamps, leave to dry:

Re: SG38 1/4 Scale (Krick)

Posted: 29 Oct 2019, 10:25
by Wayne
Main wing fixings: