-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
SG38 1/4 Scale (Krick)
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
SG38 1/4 Scale (Krick)
OK so I finally found my way back to the building board to build my long awaited 1/4 scale SG38 which I purchased several years ago.
Last edited by Wayne on 29 Oct 2019, 14:27, edited 2 times in total.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
All of the instructions for the kit are in German, fortunately when I purchased the kit a few years agao I had the foresight to source a translated version.
So if anyone else is thinking of building one of these you'll more than likely need these translated instructions which can be found here:
Hope this helps.
So if anyone else is thinking of building one of these you'll more than likely need these translated instructions which can be found here:
Hope this helps.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
OK so lets start with the fuselage:
Last edited by Wayne on 29 Oct 2019, 14:29, edited 1 time in total.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
Some of the hardware:
Last edited by Wayne on 29 Oct 2019, 09:08, edited 1 time in total.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
Fuselage and "A" frame assembly:
Last edited by Wayne on 29 Oct 2019, 14:29, edited 1 time in total.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
Wing centre section:
Last edited by Wayne on 29 Oct 2019, 10:18, edited 1 time in total.
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
LOL Yes I don't hang about, should be done by lunch time
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales
Re: SG38 1/4 Scale (Krick)
Skid Lamination & Shock Absorbers:
make up lamination spacers and angle pads for Ply, trace out from plan, make template, soak in hot water, glue bend slowly while attaching clamps, leave to dry:
make up lamination spacers and angle pads for Ply, trace out from plan, make template, soak in hot water, glue bend slowly while attaching clamps, leave to dry:
-
- Posts: 89
- Joined: 28 Oct 2019, 15:08
- Location: South Wales