Don't forget to check your spam folder if you don't get an activation email after joining!!

Cliff Charlesworth Ka3 from LCS**

Let us all watch your new project progress.
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

front brace notched to clear stringers
tb22s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

rear brace holes plugged and new holes drawn to generate the required 2.5 degrees tailplane incidence
tb23s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

v-tail covered in DIACOV
tb24s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

fuzz wing saddle horizontal
Attachments
tb25a.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

adding a 3 mm spacer, the v-tail is horizontal: angle = 2.2 degrees, close enough, please note
that the front brace was temporarily thickened to 20 mm
tb25s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

v-tail horizontal in the span direction
tb26.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

M2 screws in V-tail rear brace, notice gap between brace and stringers
tb27s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

V-tail center cover from 1 mm plywood
tb28s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

V-tail - 2 mm steel screw epoxied into 6 mm carbon rods, 3 mm copper tube increases the glue surface, carbon tube: 20 grams each
tb29s.jpg
TonyL
Posts: 129
Joined: 18 May 2021, 18:36
Location: Lyon France

Re: Cliff Charlesworth Ka3 from LCS

Post by TonyL »

elevator painted, ball epoxied to 2 mm horn at 30 mm from bend, weight 29 grams
tb30s.jpg
Post Reply