front half of ribs fitted, spacers used to clear fittings
-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
Cliff Charlesworth Ka3 from LCS**
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
glued false leading edge, spacers used to clear fittings (from the building board)
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
plywood root rib on 3 mm balsa part (to compensate for angle), root rib sanded down a little
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
skinned one side (white glue ironed on)
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
second skin ironed on, ruler is used for alignment and spacer
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
0.4 mm skins sanded down to the false leading edge
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
6 mm balsa leading edge glued on, rear rib-halves aligned and glued on, 0.8 mm plywood
trailing edge and balsa thickeners glued on
trailing edge and balsa thickeners glued on
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
rear half of root rib glued on and reinforced
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
aileron spar and subspar
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
doubled rib (cardboard spacer) and reinforcements