Page 14 of 18
Re: ORLIC
Posted: 18 Dec 2018, 16:01
by Barry_Cole
Re: ORLIC
Posted: 18 Dec 2018, 16:35
by B Sharp
Re: ORLIC
Posted: 18 Dec 2018, 16:57
by roo Hawkins
Looking good mate

Re: ORLIC
Posted: 18 Dec 2018, 16:59
by Geoff Pearce
B Sharp wrote: ↑18 Dec 2018, 16:35
I Looked!
Don't worry Geoff I can save you. There's a large pan and brush in the post and the skip lorry will arrive tomorrow morning!
Brian
That's good for me Brian
Re: ORLIC
Posted: 19 Dec 2018, 08:11
by john greenfield
Looking good Geoff....but I can't see any cutouts for the airbrakes !!?
AEB
Re: ORLIC
Posted: 19 Dec 2018, 09:30
by Geoff Pearce
john greenfield wrote: ↑19 Dec 2018, 08:11
Looking good Geoff....but I can't see any cutouts for the airbrakes !!?
AEB
Thanks John,
No I haven't done the air brakes yet, I wanted to make sure it was a good fit,
I can now do the incidence pins and make a box for air brake servo, I have some hinges that also lifts the air brake off the surface as it lays on the top according to the pics that Vince sent me.
Oh by the way I've got three pot pot engines for you
G
Re: ORLIC
Posted: 19 Dec 2018, 11:41
by Geoff Pearce
Another bit done
Spreading the load
Re: ORLIC
Posted: 30 Dec 2018, 15:08
by Geoff Pearce
I'm just winging it?
Happy new year to all the balsa bashers
Re: ORLIC
Posted: 30 Dec 2018, 15:12
by Geoff Pearce
Re: ORLIC
Posted: 30 Dec 2018, 16:10
by B Sharp
Don't worry about it Geoff - I'll do the tidy, you do the building.
Best wishes for the new year.
Brian.
