Scale Soaring UK

Wing joiner tubes available from here...

http://www.fighteraces.co.uk/product/wing-tubes/

BC

Barry_Cole wrote: ↑17 Dec 2017, 14:37 Wing joiner tubes available from here...

http://www.fighteraces.co.uk/product/wing-tubes/

BC

Thank you Barry

Just finished dry run fitting of rudder and elevators to check servos , so I can get this bit signed off , then I can finish covering the fuzz with ply.

G

MarkDev wrote: ↑20 Dec 2017, 19:28 How do the large model fin/rudder/stabiliser get 'signed off' Geoff?


See you in a week or two for more work.

M

I have an inspector from the LMA. To check the workmanship for the CAA to make sure it's airworthiness

MarkDev wrote: ↑22 Dec 2017, 19:46 What I was trying to get at was if all the pieces are inspected separately and are they tested in any way?


M

I think it's up to the examiner,

Good news, nearly finished ply covering on fuselage, LMA inspection went well finish fuse and get canopy pulled, then it's the wings
Painting comes later

G

Well done Geoff, looks like you will have your joinery indentures soon! Matt

First picture shows wiring for elevator servos, and 10mm plastic tubing for push pull rods inside for rudder .
Other three shows panels stuck to fuse. More to do

Busy weekend, thanks to Mark helping me to glass fuselage.

Resin, glass then peel ply all went well.

Also starting to finish the plug with resin and a colour additive before rubbing down

What are you people trying to do to poor Brian, you will give the poor lad a nervous breakdown.

Look away Brian..



BC