Algebra build thread

All non-scale topis should go in here for discussion.
User avatar
Peter Balcombe
Posts: 690
Joined: 18 Mar 2015, 10:13
Location: Clevedon, North Somerset, U.K.

Re: Algebra build thread

Post by Peter Balcombe » 01 Dec 2018, 09:56

Andy,
Just measured my current setup which gives the following control surface movements:

Rudder: approx. 28mm each way measured at base of rudder
Elevator: front joiner 8mm up (pitch down) & 6mm down (pitch up)
Aileron: 23mm up, 10mm down (tip end)
Flap: 0 up, 30mm down measured at root end (approx. 50 degrees)

Full Crow uses full flap, 15mm up aileron & 2mm elevator pitch down. (Not yet fully sorted)

I use coupled aileron/rudder set to 50%.

As I can set flight modes, I have launch, cruise & land modes, with crow only available in landing mode.
Hope this helps.
Peter

AndyWarlow
Posts: 18
Joined: 19 Aug 2018, 11:08
Location: Reading

Re: Algebra build thread

Post by AndyWarlow » 01 Dec 2018, 10:59

Peter,

Thanks for the info. I can now make sure I have allowed for this much movement before covering the ailerons and flaps.

Andy.

Post Reply