-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
SHK VTail mixer
SHK VTail mixer
Hi guys just a long shot but does anyone have any drawings for the Schemp Herth SHK V tail mixer unit , project pending.
- VinceC
- Site Admin
- Posts: 613
- Joined: 22 Feb 2015, 11:45
- Contact:
Re: SHK VTail mixer
Brave man. Here is a start, but still looking
- Attachments
-
- Pages from RCSD-2014-11-2.pdf
- (2.7 MiB) Downloaded 76 times
Re: SHK VTail mixer
That looks like a fairly straight forward push rod to each section of the V tail.
My guess is that the cleaver bit is up the front. If I am right then that makes it easy from a model point of view, just a servo on each push rod, and a bit of simple Rudder/Elevator mixing.
But then I could be totally wrong.
BC
My guess is that the cleaver bit is up the front. If I am right then that makes it easy from a model point of view, just a servo on each push rod, and a bit of simple Rudder/Elevator mixing.
But then I could be totally wrong.
BC
- Peter Balcombe
- Posts: 1399
- Joined: 18 Mar 2015, 10:13
- Location: Clevedon, North Somerset, U.K.
Re: SHK VTail mixer
Looks as if the forward pair of moveable arms control each main surface (pivoting on the forwardmost substantial pintels), whilst the rearmost arms (looks like cable operated) are probably for the tabs via an external rod - see photo below.
The forward arms appear to have substantial rods connected, so they may well connect to a V tail mechanism further forward.
Must be definitive info about somewhere
The forward arms appear to have substantial rods connected, so they may well connect to a V tail mechanism further forward.
Must be definitive info about somewhere
- VinceC
- Site Admin
- Posts: 613
- Joined: 22 Feb 2015, 11:45
- Contact: