I have just made up a new launch dolly based upon the side plates available elsewhere on the forum - many thanks for making it available.
After transferring the side plate details to CAD, Cliff Evans kindy cut a couple of plates for me out of 6mm ply.
I found a couple of pairs of 125mm diameter scooter wheels on FleaBay for £6.50 a pair, some M6 & M8 threaded rod plus nuts/penny washers from the local hardware shop & the result is shown below.
Yet to add cushioning foam on the top rails & give it a try.
Many thanks to Mark Deverell for answering my questions about wheels etc. etc.
-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
Launch Dolly
- Peter Balcombe
- Posts: 1399
- Joined: 18 Mar 2015, 10:13
- Location: Clevedon, North Somerset, U.K.