Don't forget to check your spam folder if you don't get an activation email after joining!!
ORLIC
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
Hi Roo,
Wing joiner aluminium tube about 32-38 MM. with carbon sailboard booms glued inside.
G
Wing joiner aluminium tube about 32-38 MM. with carbon sailboard booms glued inside.
G
- Barry_Cole
- Posts: 1422
- Joined: 10 Mar 2015, 09:30
- Location: Hampshire UK
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
Thank you BarryBarry_Cole wrote: ↑17 Dec 2017, 14:37Wing joiner tubes available from here...
http://www.fighteraces.co.uk/product/wing-tubes/
BC
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
Just finished dry run fitting of rudder and elevators to check servos , so I can get this bit signed off , then I can finish covering the fuzz with ply.
G
G
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
Good news, nearly finished ply covering on fuselage, LMA inspection went well finish fuse and get canopy pulled, then it's the wings
Painting comes later
G
Painting comes later
G
-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
First picture shows wiring for elevator servos, and 10mm plastic tubing for push pull rods inside for rudder .
Other three shows panels stuck to fuse. More to do
Other three shows panels stuck to fuse. More to do

-
- Posts: 425
- Joined: 18 Mar 2015, 09:11
- Location: SN11 9EE
Re: ORLIC
Busy weekend, thanks to Mark helping me to glass fuselage.
Resin, glass then peel ply all went well.
Also starting to finish the plug with resin and a colour additive before rubbing down
Resin, glass then peel ply all went well.
Also starting to finish the plug with resin and a colour additive before rubbing down