• Administrator
  •  
    Before your membership becomes valid, you will receive an email that must be answered.
    Please check your spam folder or this email.
     

ORLIC

Let us all watch your new project progress.
Barry_Cole

Re: ORLIC

Post by Barry_Cole »

Wing joiner tubes available from here...

http://www.fighteraces.co.uk/product/wing-tubes/

BC
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

Barry_Cole wrote: 17 Dec 2017, 14:37 Wing joiner tubes available from here...

http://www.fighteraces.co.uk/product/wing-tubes/

BC
Thank you Barry
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

Just finished dry run fitting of rudder and elevators to check servos , so I can get this bit signed off , then I can finish covering the fuzz with ply.

G
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

MarkDev wrote: 20 Dec 2017, 19:28 How do the large model fin/rudder/stabiliser get 'signed off' Geoff?


See you in a week or two for more work.😊

M
I have an inspector from the LMA. To check the workmanship for the CAA to make sure it's airworthiness
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

MarkDev wrote: 22 Dec 2017, 19:46 What I was trying to get at was if all the pieces are inspected separately and are they tested in any way?


M
I think it's up to the examiner,
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

Good news, nearly finished ply covering on fuselage, LMA inspection went well finish fuse and get canopy pulled, then it's the wings
Painting comes later

G
matt

Re: ORLIC

Post by matt »

Well done Geoff, looks like you will have your joinery indentures soon! Matt
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

First picture shows wiring for elevator servos, and 10mm plastic tubing for push pull rods inside for rudder .
Other three shows panels stuck to fuse. More to do :evil:
Geoff Pearce

Re: ORLIC

Post by Geoff Pearce »

Busy weekend, thanks to Mark helping me to glass fuselage.

Resin, glass then peel ply all went well.

Also starting to finish the plug with resin and a colour additive before rubbing down
Barry_Cole

Re: ORLIC

Post by Barry_Cole »

What are you people trying to do to poor Brian, you will give the poor lad a nervous breakdown.

Look away Brian..

:roll: :roll: :roll: :roll:

BC
Post Reply