- Posts: 198
- Joined: 22 Mar 2015, 10:27
- Location: Australia
attached some pdf files as it was done on my Nimbus glider, I used M4 socket head bolts that are permanent in the t-nut, with a small hole in the ply plaking for access with the allan key. On the Ikarus one bracket per joint will do. The Nimbus has twoper wing because of its size
the access hole can be on top or bottom of the wing.
attached some pdf files to make it all clear, see fuse drawing section F-F for the t-nut arrangement. On the M4 bolts a large diameter washer takes care of sufficient contact area. because it is a glider no locking of bolts is required due to lack of engine vibration.
Internal elastic bands on hooks is also an option but a bit difficult to fit on the field
I hope this helps
- Posts: 577
- Joined: 07 Mar 2015, 22:22
- Location: North West
Below is the method I used to retain the outer wing panels on my Skylark. It is simple, effective and quick to rig and has never failed (never come loose).
A dural block that takes a formed 8 guage piano wire insert - the forming being a simple tapered face milled onto one side of it; the rod then held tight with a 3mm socket head threaded into the block. I'm sure the photos explain it all. When assembled the socket head sits just below the wing top surface.
It would be nice to claim credit for this idea but that belongs to our member Stuart Ward from New Zealand who's efforts were somewhat more refined than mine (see below).
- Cliff Evans
- Posts: 244
- Joined: 29 Dec 2019, 15:13
- Location: Bristol