Attaching Clevis on to steel pushrod
Posted: 09 Oct 2017, 07:37
Hi all,
My new tangent glider is progressing well and I am at a stage where I need to attach the clevis's to the pre intstalled pushrods. The accesory bag contains a couple of adaptors that attach to the metal rod and then in turn the clevis screws onto this. The instructions say to epoxy these adaptors to the steel push rod.
I am not happy about this, the pushrod is about 1.5mm diameter and the hole in the adaptor 2mm, not the best of fits. I could with carefull heat protection solder them on (soft solder) but silver solder is out of the qeustion without melting the fuzz !!!!! blow torch and fibreglass don't mix
I cannot take the rods out as they are pre attached at the rudder/elevator ends
Any ideas as to the best way forward ??? I have looked at the Dubro EZ connectors
My new tangent glider is progressing well and I am at a stage where I need to attach the clevis's to the pre intstalled pushrods. The accesory bag contains a couple of adaptors that attach to the metal rod and then in turn the clevis screws onto this. The instructions say to epoxy these adaptors to the steel push rod.
I am not happy about this, the pushrod is about 1.5mm diameter and the hole in the adaptor 2mm, not the best of fits. I could with carefull heat protection solder them on (soft solder) but silver solder is out of the qeustion without melting the fuzz !!!!! blow torch and fibreglass don't mix
I cannot take the rods out as they are pre attached at the rudder/elevator ends
Any ideas as to the best way forward ??? I have looked at the Dubro EZ connectors