After joining, please check your email and spam folder for the confirmation email. Without this being answered your membership is not activated.
Anything to do with gliders & gliding.
- Posts: 87
- Joined: 18 Mar 2015, 20:46
- Location: Norfolk. Premier slope soaring country.
I am just fitting out a Swift with a retract and am not sure of the best way to add something to retract the doors when the wheel retracts.
Any advice would be helpful. What system do you use etc.
- Posts: 1315
- Joined: 10 Mar 2015, 09:30
- Location: Hampshire UK
You can power them with small servos. (Very complicated)
A small tension spring works well, as you can make it push the doors open wide to get more ground clearance.
It really depends on how much space you have, and the mechanics of the retract.
Maybe someone could post a few photos of what they have done.
- Posts: 1044
- Joined: 10 Mar 2015, 10:50
- Location: Blandford Dorset
This is how I've done it on my various Dart 17's...
- Posts: 797
- Joined: 18 Mar 2015, 20:12
- Location: Northamptonshire
I use 2 elastic bands one for each door.
- Posts: 220
- Joined: 20 Mar 2017, 22:09
- Location: UK
Like Roo ,I use rubber bands to close the doors which pull the doors when u/c legs go horizontal. The same system as used full size substituting bungees for rubber bands. Regards John.
- Posts: 202
- Joined: 18 Mar 2015, 08:18
- Location: West Wales
I use rubber bands too, sometimes actually connected to the retract arm so that the tension increases as it retracts.
Have now resorted to using silicone for the hinges, which works way better than anything else and is super resilient.