Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 09:42
With the rudder made up and hinged to the fin, the whole assembly can be glued to the fuselage, thus completing this part of the process...
BC
Scale Soaring UK
The forum for all your modelling requirements relating to scale gliders
https://scalesoaring.co.uk/phpBB3/
ZUGVOGEL IIIa 1/4.2 SCALE
Page 3 of 10
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 11:11
Try not to knock it off this time....
BC
BC
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 13:55
Yeah, that'll be known as criminal activity 
Geoff
Geoff
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 14:37
Next he will be telling us he has run out of servos. Who would do that??
BC
BC
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 15:10
Just had a visit from the Servo Fairy...
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 15:57
I know he's a bit short, but that's going a bit far....
BC
BC
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 06 Apr 2020, 17:01
Mmmm, obviously going to have to change those shorts 
Still, on another note, i wonder if i'll find a couple of quid under my pillow tomorrow morning ???? 
Geoff
Still, on another note, i wonder if i'll find a couple of quid under my pillow tomorrow morning ???? Geoff
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 07 Apr 2020, 09:48
Moving on now to the wings...pretty conventional stuff: single 15mm wing joiner, and the aileron spar is located by the ends of the sub-ribs...
The ribs are 2.4mm balsa and the main spar 5mm sq spruce.
The ribs are 2.4mm balsa and the main spar 5mm sq spruce.
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 08 Apr 2020, 11:27
That's better, well done Cliff...Time for a dihedral check before committing epoxy...
Re: ZUGVOGEL IIIa 1/4.2 SCALE
Posted: 08 Apr 2020, 15:34
You are welcome!