pre-forming the (wet) leading edge of 0.4 mm ply around a steel tube
-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
Cliff Charlesworth Ka3 from LCS**
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
half-rounds formers for leading edge
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
half-rounds formers for leading edge and hinge
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
half-rounds around hinge and shaped 0.4 mm ply leading edge
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
I will be travelling next week, so an early update:
elevator finished: 19 grams
elevator finished: 19 grams
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
0.4 mm shroud and balsa reinforcement
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
complete V-tial
-
- Posts: 129
- Joined: 18 May 2021, 18:36
- Location: Lyon France
Re: Cliff Charlesworth Ka3 from LCS
v-tail front brace height temporarily increased to 20mm (= height rear brace) to simplify alignment