-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
Gloster Meteor F3 for PSS
- Andy.Meade
- Posts: 31
- Joined: 18 Mar 2015, 09:56
Gloster Meteor F3 for PSS
After seeing a large turbine powered Meatbox at an LMA show at Gaydon, I knew I had to get one on the slope. This is my own design all in balsa and ply, other than the engine nacelles which are 3D printed shells. She flies a treat, and is a pussycat to land with the flaps. 69" span, glassed then sprayed in acrylics.
- Peter Balcombe
- Posts: 1399
- Joined: 18 Mar 2015, 10:13
- Location: Clevedon, North Somerset, U.K.
Re: Gloster Meteor F3 for PSS
Very nice job Andy
-
- Posts: 577
- Joined: 30 May 2015, 20:35
- Location: Sutton Bank, North Yorkshire
Re: Gloster Meteor F3 for PSS
That looks fab Andy. The outlines look very scale.
Which wing section did you use and what’s the flying weight?
Rog
Which wing section did you use and what’s the flying weight?
Rog
- Andy.Meade
- Posts: 31
- Joined: 18 Mar 2015, 09:56
Re: Gloster Meteor F3 for PSS
I wish I could remember! It is written inside somewhere - 8lb I seem to remember, blessed short noses and long tails! Wing section was the evergreen Eppler 374.
Thanks both for the comments.
Thanks both for the comments.