Here’s a poser/head scratcher.
I’m running 2 X 5000mah 6v through a power box Jeti switch, powering 6v servo’s except for the two elevator servo’s which are futaba (equivalent) 3150’s rated to 4.8v.
My question is, the output voltage through the switch and rx is 5.4v, this is fine for the the larger servo’s but what about the two 4.8v servo’s, taking into account that a 4 cell 4.8v charged battery going though a normal on/off switch produces more than the 5.4v with no adverse effects.
TIA.
-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
4.8v servos.
-
- Posts: 36
- Joined: 31 Jan 2020, 16:17
- Location: East Yorkshire
Re: 4.8v servos.
Your nominal 4.8 volt servo,s should be fine on a regulated 5.4 volts , they just don't like a fully charged 5 cell battery , which can be over 7 volts
Ian Turney-White
Ian Turney-White
-
- Posts: 20
- Joined: 25 Apr 2021, 08:42
- Location: Midlands
Re: 4.8v servos.
Thanks Ian.IanT-White wrote: ↑26 Oct 2021, 18:48 Your nominal 4.8 volt servo,s should be fine on a regulated 5.4 volts , they just don't like a fully charged 5 cell battery , which can be over 7 volts
Ian Turney-White