Page 1 of 2
Wing joiner
Posted: 05 Jan 2022, 20:19
by JamesH
Evening I'm building a Scheibe-Loravia Topaz the plan uses a 14mm graupner steel bar & brass box which is like rocking horse
.
I can source 12mm and 15mm but what would everyone recommend. Many thanks
Re: Wing joiner
Posted: 05 Jan 2022, 20:34
by chris williams
James, you can't get the 14mm any more. The 15mm will be fine, just adapt the ply support accordingly... (Note the brass box is 16mm)
Re: Wing joiner
Posted: 05 Jan 2022, 21:19
by JamesH
chris williams wrote: ↑05 Jan 2022, 20:34
James, you can't get the 14mm any more. The 15mm will be fine, just adapt the ply support accordingly... (Note the brass box is 16mm)
Thanks for that, as I'm not 100% sure are you the same person as the designer ?? If so ive got 1 more question about the F6a retro fit
Re: Wing joiner
Posted: 05 Jan 2022, 21:55
by Trevor
Quick Chris - deny everything!
Re: Wing joiner
Posted: 05 Jan 2022, 22:14
by chris williams
No prob James, fire away...
Re: Wing joiner
Posted: 05 Jan 2022, 23:23
by Barry_Cole
Re: Wing joiner
Posted: 06 Jan 2022, 07:21
by JamesH
Re: Wing joiner
Posted: 06 Jan 2022, 07:28
by JamesH
Ok on the plan I've got f6a is a piece which is angled in front of former f6 but I've seen a different set of plans where there's a f6a former between f6 and f7. I'm not sure if it should have one there's definitely not one in the laser pack just wondering if it's been missed off by sarik or just not needed cheers.
Re: Wing joiner
Posted: 06 Jan 2022, 09:51
by chris williams
First up, James, have you had all the build pics from me...!
Re: Wing joiner
Posted: 06 Jan 2022, 10:00
by JamesH
chris williams wrote: ↑06 Jan 2022, 09:51
First up, James, have you had all the build pics from me...!
Yes I have
.
