-
- Administrator
-
-
Before your membership becomes valid, you will receive an email that must be answered.
Please check your spam folder or this email.
1:4 Scale 5m Horton III designed by Jilles Smits
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
1:4 Scale 5m Horton III designed by Jilles Smits
This is from Laser Cut sail Planes and is a real builders model.
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
I going to start will the center section and then build the wings from that.
-
- Posts: 101
- Joined: 26 Jun 2022, 00:51
- Location: Hampshire
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
You need a bigger bench Rich.
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
Started center section top sheeting. Wheel gondola formers removed to allow center section to sit flat on building board.
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
Sheeting continuing and drive shaft install
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
wing constrution started with joiner tubes anbd spars
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
-
- Posts: 42
- Joined: 18 May 2017, 21:06
- Location: Townsville. North Qld
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
Hi Rich,
Watching this build with interest from down under in Oz.
Keep those photos coming along.
Lawriep
Watching this build with interest from down under in Oz.
Keep those photos coming along.
Lawriep
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
First wing released from center section, assembled and sheeted on top surface. Each wing panel is 2500mm long from cernter section to tip.
-
- Posts: 44
- Joined: 19 Mar 2015, 19:52
Re: 1:4 Scale 5m Horton III designed by Jilles Smits
Control surfaces removed from wings and completed